Remedy: (1) Take off the FAX board if installed.Description: SRAM and NVRAM abnormality on the SYS board.If the error is not recovered, replace the NVRAM on the SYS board. - - - (19) Turn the power OFF and then back ON. (14) Start up with FAX Clearing Mode (1*). (13) Set the destinetion with gDestination setting of FAX machineh (08-701). (12) Start up with the Setting Mode (08). * If the FAX board has not been installed, the following steps are not necessary.
#Battlefield 4 servers install
(11) Install the FAX board taken off in step (1). (9) Initialize the NIC information (08-693).
#Battlefield 4 servers serial number
Entering the incorrect serial number may result in an inability to access the network due to an invalid MAC address. Note: The MAC address of the equipment is generated based on this serial number. If the number is different from the one on the label attached to the rear cover of the equipment, enter the correct serial number again with 08-995. (8) Check the serial number after performing gEquipment number displayh (08-995).
(7) Perform the initialization at the software version upgrade (08-947). (6) Perform the counter copying (08-257 Sub-code: 1). (NVRAM initialization will start.) (5) Perform the panel calibration (08-692). (4) When the confirmation messege appears on the LCD screen, press the button. If the destination is correct, key in the correct number and press the button. (3) When the messege gNVRAM ERROR DOES IT INITIALIZEh is displayed on the LCD screen, check the destination and then press the button. Note: Be sure to start up with the Setting Mode (08), not the normal mode immediately after the NVRAM replacement or clearing, and then perform the following steps. (2) Turn the power OFF and start up with the Setting Mode (08).
0 kommentar(er)
